Our Brands

Development Boards

99 - 113
107 108 109 110 111 112 113 114 115 116 117 118 119 120 121
115 - 129
Newest Items First
15 Per Page
2716-ADA Adafruit Silicon MEMS Microphone Breakout - SPW2430
US$8.67
This breakout is best used for projects such as voice changers, audio recording/sampling, and audio-reactive projects that use FFT. To keep the breakout small and simple, we only added a 3V voltage regulator (the microphone requires 3.3V DC) and filter capacitors.
Delivery within 2-3 weeks
+ −
Add to wish list
2717-ADA TCA9548A I2C Multiplexer
US$12.17
Finally, a way to get up to 8 same-address I2C devices hooked up to one microcontroller - this multiplexer acts as a gatekeeper, shuttling the commands to the selected set of I2C pins with your command.
In stock
+ −
Add to wish list
BB-MICROUSB Micro-B USB BreakOut Board
US$1.53
Give your projects usb support, great for supply 5v for your breadboard projects or interfacing with your microcontroller. It has the typical five pins assessable for your needs.
In stock
+ −
Add to wish list
ARD-UNO-DEV DIY 8 Bit Arduino Microcontroller
US$27.93
The in-depth manual explains about through hole soldering, a glance at FTDI and serial communication how the Arduino plugs into the pc and is automatically detected and the basic explanations on circuit analysis for the Arduino Uno microcontroller. Using this knowledge it can be applied to any Arduino microcontrollers and give a basic understanding of microcontrollers.
In stock
+ −
Add to wish list
ARD-FTDI FTDI Serial Adapter 5V / 3.3V Logic levels USB to TTL
US$10.93
Scratching your heading, searching through the pile of tangled cables, found the 5v logic cable but you need the 3.3v cable? Eliminate this scenario all together with this FTDI to Serial Adapter chip. Contains 6 pins and a mini USB B to USB A connector to interface with your Arduino Pro Mini, Raspberry pi and plethora of sensors.
In stock
+ −
Add to wish list
WIFI-ESP-12E IoT - Wireless Internet of Things Mini Micro-Controller
US$9.45
Looking for a low power wireless component to add onto your projects? This lightweight (L)2.4cm x (W)1.6cm x (H)0.1cm has not one but 10 GPIOs, requires an FTDI Cable to program. Use this device as slave and communicate from your mobile device to activate relays, read values or any other ideas you may have from ~10 meters.
In stock
+ −
Add to wish list
PI2-CASE-BLACK Raspberry Pi 2 Enclosure - Black
US$10.71

This black case for the Raspberry Pi2 provides slots to access the peripheral header, USB ports, Ethernet, SD card, HMDI, composite video, audio, CSI and JTAG connectors as well as feet and vents to ensure the board gets proper cooling and plus-shaped wall mounting slots.

In stock
+ −
Add to wish list
ARD-MEGA Arduino Mega2560 Compatible Development Board
US$31.80
This is an Arduino compatible R3 Mega2560 ATmega2560-16AU control board. Comes with USB cable.
In stock
+ −
Add to wish list
WRL-12938 SparkFun FM Tuner Evaluation Board - Si4703
US$36.03
This is an evaluation board for the Silicon Laboratories Si4703 FM tuner chip. Beyond enabling you to tune in to FM radio stations, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job of filtering and carrier detection.
In stock
+ −
Add to wish list
ARD-PROMINI-3.3V Arduino Pro Mini ATmega328P-AU 3.3V Micro controller at 8Mhz
US$10.32
The 3.3V Arduino Pro Mini Micro controller is based on the ATmega328P-AU chip set and runs at 8 Mhz. It comes with two 12 pin headers and one 6 pin
angled connector for header based connections, some soldering is required.
In stock
+ −
Add to wish list
ARD-PROMINI-5V Arduino Pro Mini ATmega328P 5v Micro controller at 16Mhz
US$17.06
The 5V Arduino Pro Mini Micro controller is based on the ATmega328P chipset and runs at 16 MHz. It comes with two 12 pin headers and one 6 pin
angled connector for header based connections, some soldering is required.
In stock
+ −
Add to wish list
Arduino Pro
ARD-PROMICRO-5V Micro Atmega32U4 5V/16MHz Arduino Module Board
US$13.93
The Pro Micro - 5V/16MHz- is similar to the Pro Mini except with an ATmega32U4 on board.
In stock
+ −
Add to wish list
2755-POLOLU Dual MC33926 Motor Driver for Raspberry Pi (Partial Kit)
US$124.42
This add-on board enables a Raspberry Pi B+, A+, or Pi 2 to drive a pair of brushed DC motors. Its dual MC33926 motor drivers operate from 5 V to 28 V and can deliver a continuous 3 A (5 A peak) per motor.
In stock
+ −
Add to wish list
WIFI-ESP8266 WiFi Serial Transceiver Wireless Module w/ ESP8266 ESP-01- 1MB Flash
US$6.96
The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all Wi-Fi networking functions from another application processor.
In stock
+ −
Add to wish list
DEV-13630 SparkFun Photon Weather Shield
US$46.13
The SparkFun Photon Weather Shield is an easy to use add-on board that grants you access to barometric pressure, relative humidity, and temperature. There are also connections on this shield to optional sensors such as wind speed, direction, rain gauge and soil readings!
In stock
+ −
Add to wish list
99 - 113
107 108 109 110 111 112 113 114 115 116 117 118 119 120 121
115 - 129