Electromechanical

US$6.99
This fuse is to be used in applications where a high amount of voltage is applied. Found in electric solar systems and automotive multimeters.
In stock
+
Add to wish list

US$6.99
This fuse is to be used in applications where a high amount of voltage is applied. Found in electric solar systems and automotive multimeters.
In stock
+
Add to wish list

US$6.99
This fuse is to be used in applications where a high amount of voltage is applied. Found in electric solar systems and automotive multimeters.
In stock
+
Add to wish list

US$6.99
This fuse is to be used in applications where a high amount of voltage is applied. Found in electric solar systems and automotive multimeters.
In stock
+
Add to wish list

US$2.09
Electromechanical Relay rated for 24VDC 20Amps Single Pole, Double Throw that is Normally Open. Recommend for high power systems like Motor Load Switching, and many more.
In stock
+
Add to wish list

US$1.39
This tube will allow you to move the water from one location to another with the help of a water pump that adapts to it.
In stock
+
Add to wish list

US$3.49
This diaphragm pump is the perfect choice for any project that requires liquid to be moved from one place to another. The pump requires a hose that you can cut to your requirements, the hose provides a good seal and will not leak. Recommended hose : 6mm inner diameter.
In stock
+
Add to wish list

US$6.59
  Switch rotary adjustable 1/4”, non-shorting round shape, 1 pole, positions: 8, shaft length: 3/8”, make before-break, solder terminals-FIG.A....
In stock
+
Add to wish list

US$6.59
This is an adjustable rotary switch 1/4”, non-shorting, D-shaft, 1 pole, selectable positions: 12, make-before-break, shaft length: 1/2”, PCB solder-fig. B....
In stock
+
Add to wish list

US$15.33
This motor driver module can handle up to 48 volts and handle a maximum of 1 amp of current. Based on the L6201, a full bridge drive controller board allowing for backwards and forwards motion which is similar to the L298N.
In stock
+
Add to wish list

US$13.42
This is a Bidirectional 2-channel HIGH and LOW-level trigger relay, apply to Arduino and Raspberry Pi. The module has good quality power relay, ultra-small package optocouplers, high power dielectric transistor, RED signal lights, double side military-grade PCB plate and works with full noises immunity and stable performance. It can be widely used in varieties of power control occasions.
In stock
+
Add to wish list

US$24.95
This is a four channel WiFi module equipped with an ESP-01 WiFi module (8 bit MCU) that can be controlled from anywhere anytime using the Internet!
In stock
+
Add to wish list

US$21.46
This NEMA 23 Motor Mount Plate is designed to easily allow for the modular connection of a NEMA 23 Stepper Motor.
In stock
+
Add to wish list

US$39.87
This linear actuator kit consists of a stepper motor-actuator assembly along with a stepper motor driver that can be controlled with either the buttons mounted on it or by an included remote control. The speed and direction of the rotation can be adjusted with the buttons located on the driver board. A seven segment display indicates the current speed the motor is spinning at.
In stock
+
Add to wish list

US$25.94
Each consist of a tiny dual phase stepper motor with a threaded shaft attached to it. As the shaft rotates, a sliding nut moves linearly back and fourth depending on the direction of rotation coming from the motor. They are not the most precise and powerful actuators but they'll do the job for a small plotter or laser engraver.
In stock
+
Add to wish list