5VDC Photosensitive 1-Channel Relay Module
This product features photosensitive light sensor, this sensor will detect and measure the amount of ambient light and trigger the relay accordingly. Varying on the intesity of the light you have selected by adjusting the potentiometer, you can trigger the relay to create a closed circuit to allow your high voltage devices to operate. Otherwise, you can create an open circuit to shut down your connected devices.
Supply 5V Dc to the two pin screw terminal block where +5V goes into Vcc and Ground in GND. The photoresistor is removable using the JST-Ph connector and your load is connected to the three pin screw terminal block.
Specifications:
- Operating Voltage for module: 5V DC
- Relay Load (maximum): 10A @ 250VAC/ 10A @ 30VDC
- Dimensions: 52 x 31 x 31mm (LxWxD)
- Mounting Hole Diameter: 3mm
WARNING
