Our Brands

Wireless

6 - 20
14 15 16 17 18 19 20 21 22 23 24 25 26
Newest Items First
15 Per Page
WIFI-RTL8710 RTL8710 Development Board Micro-Controller
US$19.95
Realtek RTL8710 is a Wi-Fi Module that is great for Internet of Things projects. This IC that is surface mounted on the microcontroller is based on an ARM Cortex-M3 Processor 166MHz. The processor has a 1MB ROM, 512KB RAM and a build in 1MB Flash memory with faster wireless performance compared to the ESP8266. This module uses the FreeRTOS as the go-to operating system and be programmed thanks to the CH340 IC with a Micro USB port. You have access to 17 GPIOs, 3 I2C, 2 PCM, 4 PWM and two high speed and one low speed UART. This board can be programmed with Arduino bootloader and offers wireless connectivity at b/g and n signals.
In stock
+ −
Add to wish list
WIFI-ESP8266-B ESP8266 Adapter Board
US$3.49
This plain looking board allows users to connect ESP-01 Wi-Fi module to a FTDI chip or breadboard and program with 3.3 or 5vdc logic levels. This board has a ASM1117 IC that allows you to using the FTDI chip at any logic level making it easy for you to power the system and not worry about frying the ESP chip. The ESP8266 is popular and can be found in Sonoff wireless relays or server and can even act like an Arduino with the correct board manager and Arduino code. This adapter board helps to achieve all these functions and not worry about 3.3v logic level signals.
In stock
+ −
Add to wish list
ANT-15 3DBI Spring Antenna for SIM800L
US$1.39
This is a simple antenna designed for SIM800L GPRS boards, or for any board that requires an antenna to be soldered onto! Specifications: Signal gain: 3DBi. Length: 1.5cm. Width: 0.4cm. Material: Nickel Plating.
In stock
+ −
Add to wish list
ANT-17 GSM u.FL Connector to SMA Antenna
US$4.89
This product is an extension to the ABRA product WL-340 SIM800L GPRS GSM Breakout Module. The module broadcasts on a 3G network allowing you to send or receive data from this device. This device is the secondary antenna that accompanies the spring antenna. It easily connects to the PCB by a UFL connector.
In stock
+ −
Add to wish list
WL-70 Wireless Remote with Receiver 315MHz 4 Channel
US$6.99
This practical wireless radio remote can be used for many alternative applications around the house or car. The device has a strong operating power rating and great transmission distance. The four buttons each occupy a 315 Mhz channel and respectively correspond to the four data bits sent to the receiving board (data bit is output high).
In stock
+ −
Add to wish list
WIFI-SONOFF-R 433MHz Remote Control for SONOFF RF Switch
US$10.70
This remote control looks and feels like any normal car starter, expect this device is designed to work with the SONOFF relay. You can mount the relay to control 110VAC applications at a max of 10Amps. Great for project ideas like an remote control car door opener or anything that run on high AC voltage. This switch can operate for an entire year without needing to replace the battery, varying on usage.
In stock
+ −
Add to wish list
2633-ADA Adafruit Bluefruit LE SPI Friend - Bluetooth Low Energy (BLE)
US$34.92
The Bluefruit LE SPI Friend makes it easy to add Bluetooth Low Energy connectivity to anything with 4 or 5 GPIO pins. With SPI, you don't have to worry about baud rates, flow control, or giving up a hardware UART port. Connect to your Arduino or other microcontroller using the common four-pin SPI interface (MISO, MOSI, SCK and CS) plus a 5th GPIO pin for interrupts (to let the Arduino know when data or a response is ready).
In stock
+ −
Add to wish list
3231-ADA Adafruit LoRa Radio FeatherWing - RFM95W 900 MHz
US$34.92
This is the LoRa 9x @ 900 MHz radio version, which can be used for either 868MHz or 915MHz transmission/reception - the exact radio frequency is determined when you load the software since it can be tuned around dynamically. These are +20dBm LoRa packet radios that have a special radio modulation that is not compatible with the RFM69s but can go much much farther. They can easily go 2 Km line of sight using simple wire antennas, or up to 20Km with directional antennas and settings tweakings.
In stock
+ −
Add to wish list
AM-145 Xbee USB Bluetooth Adapter for Arduino
US$13.78
This device allows users to connect their XBee and interface by using a simple USB Cable. The unit comes with voltage protection and regulation circuits to prevent any damage to the XBee. It also has the FT232 from FTDI to allow easy connection to any Windows/Apple or Linux computers. This device can also be used as a FTDI programmer for Arduino Micro.
In stock
+ −
Add to wish list
WL-330 nRF24L01+PA+LNA with Antenna 2.4GHz Wireless Transceiver
US$13.99
This is an Arduino and Raspberry pi compatible 2.4Ghz Wireless Transceiver. It allows you to send and receive data from a distance of 800+ meters in the light of sight. This board comes with a RFX2401C chipset that offers power amplification and low noise amplification in one tiny unit. Using SPI Protocol you can communicate to this device and send/receive commands at a rate of 250kbps – 2Mbps. This unit comes with a 2.4Ghz 2.2 dBi Antenna.
In stock
+ −
Add to wish list
BB-ESP8266 Breakout Board For ESP8266
US$1.53
If you are planning on purchasing an ESP8266 you will often find yourself wondering on how to interface this component into your projects or breadboard. This breakout board changes the small spacing on the ESP to a wider spacing compatible for the breadboards. It also has a trace on the back that allows users to surface mount voltage regulators to protect their ESPs. It also comes with header pins that require soldering.
In stock
+ −
Add to wish list
3071-ADA Adafruit RFM69HCW Transceiver Radio Breakout - 433 MHz
US$15.95
Sending data over long distances is like magic, and now you can be a magician with this range of powerful and easy-to-use radio modules. Sure, sometimes you want to talk to a computer (a good time to use WiFi) or perhaps communicate with a Phone (choose Bluetooth Low Energy!) but what if you want to send data very far? Most WiFi, Bluetooth, Zigbee and other wireless chipsets use 2.4GHz, which is great for high speed transfers.
Delivery within 2-3 weeks
+ −
Add to wish list
WAVE-114-CB Bluetooth 4.0 NRF51822 Core Board
US$13.93
Core51822 is a wireless module based on nRF51822 - the Multiprotocol Bluetooth® 4.0 low energy/2.4 GHz RF SoC designed for ULP (ultra low power) wirelesss applications. Features include: 2.4 GHz multiprotocol RF transceiver, ARM® Cortex™-M0 32 bit processor, 128 bit AES HW encryption, 256kB flash & 32kB RAM, Programmable Peripheral Interconnect (PPI), Digital interfaces: SPI, I2C, UART, 10 bit ADC.
In stock
+ −
Add to wish list
Digital USB TV FM+DAB+DVB-T+ SDR Support Stick dongle with Receiver antenna(RTL2832U+R820T)
US$31.80
A powerful Digital Video Broadcasting – Terrestrial and Software-defined Radio Tuner is a great device to listen to radio channels or watch digital video channels using your computer.
In stock
+ −
Add to wish list
WL-201 Adapter socket for 8-pin wifi transceiver module
US$3.21
This small module makes connecting a wifi transceiver to a project way easier! It converts logic from 5V down to the 3.3 used by the NRF24L01+ moduleslike the WIFI-ESP8266, and labels the pins for an easier connection.
In stock
+ −
Add to wish list
6 - 20
14 15 16 17 18 19 20 21 22 23 24 25 26