Our Brands

Development Boards

96 - 110
104 105 106 107 108 109 110 111 112 113 114 115 116 117 118
112 - 126
Newest Items First
15 Per Page
PI-100 Micro USB to DC power Adapter for Raspberry Pi
US$2.98
This little wire will let you connect one of our 5V 2Amp adapters (276-ADA) to something that expects to be connect to Micro USB. One end has a Micro USB female jack and the other end is a 'standard' 5.5mm O.D (Outer Dimension) / 2.1mm (I.D) Inner Dimension DC jack with center positive polarity. 
In stock
+ −
Add to wish list
ARD-200 RS232 to TTL Converter Interface Module
US$11.35
This product comes in handy when you are working with a computer that has RS232 ports available, instead of fumbling for precious USB I/O ports you can connect this device straight into the RS232 port.
In stock
+ −
Add to wish list
PGM-PIC-3 Pickit 3 Programmer
US$68.20
The PICkit 3 allows debugging and programming of PIC and dsPIC microcontrollers using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to a PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2/ 3 and MPLAB REAL ICE).
In stock
+ −
Add to wish list
PGM-AVR-10 AVR USBtiny programmer
US$17.97
This premade board acts like a AVR programmer and uses SPI Interface. Works with avrdude (cmd) or avrdudess (GUI) and AVRStudio-compatible. You can flash firmwares using this tiny programmer or bitbang commands to avr chipsets.
In stock
+ −
Add to wish list
PGM-AVR-5 AVR USBASP Programmer
US$10.32
This programmer is based on Thomas Fischl’s USBasp design and connects your computer’s USB port to your microprocessor using SPI. This device is supported in AVRDude version 5.2 and onwards, Allows you to read/write to any atmel based microprocessors. Works in windows 7/8/10, Mac and Linux.
In stock
+ −
Add to wish list
2716-ADA Adafruit Silicon MEMS Microphone Breakout - SPW2430
US$8.67
This breakout is best used for projects such as voice changers, audio recording/sampling, and audio-reactive projects that use FFT. To keep the breakout small and simple, we only added a 3V voltage regulator (the microphone requires 3.3V DC) and filter capacitors.
Delivery within 2-3 weeks
+ −
Add to wish list
2717-ADA TCA9548A I2C Multiplexer
US$12.17
Finally, a way to get up to 8 same-address I2C devices hooked up to one microcontroller - this multiplexer acts as a gatekeeper, shuttling the commands to the selected set of I2C pins with your command.
Delivery within 2-3 weeks
+ −
Add to wish list
BB-MICROUSB Micro-B USB BreakOut Board
US$1.53
Give your projects usb support, great for supply 5v for your breadboard projects or interfacing with your microcontroller. It has the typical five pins assessable for your needs.
In stock
+ −
Add to wish list
ARD-UNO-DEV DIY 8 Bit Arduino Microcontroller
US$27.93
The in-depth manual explains about through hole soldering, a glance at FTDI and serial communication how the Arduino plugs into the pc and is automatically detected and the basic explanations on circuit analysis for the Arduino Uno microcontroller. Using this knowledge it can be applied to any Arduino microcontrollers and give a basic understanding of microcontrollers.
In stock
+ −
Add to wish list
ARD-FTDI FTDI Serial Adapter 5V / 3.3V Logic levels USB to TTL
US$10.93
Scratching your heading, searching through the pile of tangled cables, found the 5v logic cable but you need the 3.3v cable? Eliminate this scenario all together with this FTDI to Serial Adapter chip. Contains 6 pins and a mini USB B to USB A connector to interface with your Arduino Pro Mini, Raspberry pi and plethora of sensors.
In stock
+ −
Add to wish list
WIFI-ESP-12E IoT - Wireless Internet of Things Mini Micro-Controller
US$9.45
Looking for a low power wireless component to add onto your projects? This lightweight (L)2.4cm x (W)1.6cm x (H)0.1cm has not one but 10 GPIOs, requires an FTDI Cable to program. Use this device as slave and communicate from your mobile device to activate relays, read values or any other ideas you may have from ~10 meters.
In stock
+ −
Add to wish list
PI2-CASE-BLACK Raspberry Pi 2 Enclosure - Black
US$10.71

This black case for the Raspberry Pi2 provides slots to access the peripheral header, USB ports, Ethernet, SD card, HMDI, composite video, audio, CSI and JTAG connectors as well as feet and vents to ensure the board gets proper cooling and plus-shaped wall mounting slots.

In stock
+ −
Add to wish list
ARD-MEGA Arduino Mega2560 Compatible Development Board
US$31.80
This is an Arduino compatible R3 Mega2560 ATmega2560-16AU control board. Comes with USB cable.
In stock
+ −
Add to wish list
WRL-12938 SparkFun FM Tuner Evaluation Board - Si4703
US$34.23
This is an evaluation board for the Silicon Laboratories Si4703 FM tuner chip. Beyond enabling you to tune in to FM radio stations, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job of filtering and carrier detection.
In stock
+ −
Add to wish list
ARD-PROMINI-3.3V Arduino Pro Mini ATmega328P-AU 3.3V Micro controller at 8Mhz
US$10.32
The 3.3V Arduino Pro Mini Micro controller is based on the ATmega328P-AU chip set and runs at 8 Mhz. It comes with two 12 pin headers and one 6 pin
angled connector for header based connections, some soldering is required.
In stock
+ −
Add to wish list
96 - 110
104 105 106 107 108 109 110 111 112 113 114 115 116 117 118
112 - 126