PS-360-12 Switchable 110/220VAC 12VDC 66A Power Supply with Fan.
This power supply was designed specifically for 3D printers. The unit is equipped with 3 voltage outputs and common ground terminals.
For protection, we recommend using 14AWG or 16AWG multi-braided wire gauge. To avoid damage to the board, do not tin the wires before attaching onto terminal block and pay special attention to the board`s polarity.
SPECIFICATIONS:
|
Model Specification |
S-800-12 |
|
DC Output voltage |
12V |
|
Output voltage range |
+/-1% |
|
Rated output current |
66A |
|
Output current range |
0~66A |
|
Wave and noise(Note:3) |
150mVp-p |
|
Inlet stability(Note:4) |
+/-1% |
|
Load stability(Note:5) |
+/-1% |
|
DC output power |
800W |
|
Efficiency |
84% |
|
Adjustable range for DC voltage |
+/-10% |
|
AC input voltage range |
100~132VAC/190~240VAC 250~340VDC |
|
Input current |
6A/230V |
|
AC Inrush current |
Cold-start current 30A/115V, 60A/230V |
|
Leakage current |
less 3.5mA/240VAC |
|
Overload protection |
105%-150% Type: cut down output Reset: auto recovery |
|
Over-voltage protection |
................. |
|
High-temperature protection |
.................... |
|
Temperature coefficient |
+/-0.03%/.C(0~50.C) |
|
Setup, rise, hold up time |
800ms, 50ms, 10ms/150V 300ms,50ms,80ms/230v |
|
Vibration |
10~500Hz, 2G 10min,/1 cycle. Period for 60min, each axes |
|
Withstand voltage |
I/P-O/P:1.5K VAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC |
|
Isolation resistance |
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC |
|
Working temperature and humidity |
-10.C~ +60.C(Refer to output derating curve), 20%~90%RH |
|
Store temperature and humidity |
-20.C~ +85.C, 10%~95%RH |
|
Overall dimension |
238*124*65mm (L*W*H) |
