WAVE-30941, ESP32-C6 1.9inch Display Development Board, Supports 90° Hardware Rotation, With Touch Function
ESP32-C6 1.9inch LCD Display Development Board
170 × 320, Embedded with ST7789V2 Display Driver, Supports 90° Hardware Rotation
This product adopts ESP32-C6FH8 chip with 2.4GHz Wi-Fi 6 and Bluetooth BLE 5 support, integrates 8MB Flash. Onboard 1.9inch LCD display which can smoothly run GUI programs such as LVGL. Onboard QMI8658 6-axis IMU, TF card slot, Lithium battery header, etc. Compatible with Pico header, offering strong compatibility and expandability. It is suitable for the quick development of the HMI and other ESP32-C6 applications.
- Equipped with a high-performance 32-bit RISC-V processor with clock speed up to 160 MHz
- Supports 2.4GHz Wi-Fi 6 (802.11 b/g/n) and Bluetooth 5 (LE), with an onboard antenna
- Built-in 512KB HP SRAM, 16KB LP SRAM, and 320KB ROM, integrates 8MB Flash
- Onboard 1.9inch LCD display, 170 × 320 resolution, 262K color, delivering clear and vivid color image display
- Onboard QMI8658 6-axis IMU (3-axis accelerometer and 3-axis gyroscope) for detecting motion gestures, counting steps, etc.
- Onboard USB Type-C port for power supply, program downloading, and debugging
- Onboard 3.7V MX1.25 Lithium battery recharge/discharge header
- Onboard TF card slot for external TF card storage
- Compatible with Pico header, onboard multiple peripheral interfaces, offering strong compatibility and expandability
LCD parameters
| Display Panel | LCD | Display Size | 1.9 inch |
|---|---|---|---|
| Resolution | 170×320 | Display Colors | 262K |
| Brightness | 500 cd/㎡ | Contrast Ratio | 900:1 |
| Communication Interface | SPI | Driver IC | ST7789V2 |
| Touch | Supported (Touch Version Only) | Touch IC | CST816 (Touch Version Only) |
Software Support: ESP-IDF, Arduino IDE
Wi-Fi and BLE 5: ESP32-C6 supports 2.4 GHz Wi-Fi (802.11 ax/b/g/n) and Bluetooth 5 LE + Mesh.
Interface Definition: Compatible with Pico header, can be used with some Raspberry Pi Pico HATs.
What's On Board
- ESP32-C6FH8
Integrates 8MB Flash, up to 160MHz operating frequency - TCA9554
8-ch GPIO expander chip, enhances IO flexibility - MX1.25 battery header
MX1.25 2PIN connector, for 3.7V Lithium battery, supports charging and discharging - RESET button
- USB Type-C port
For power input and data transmission - TF card slot (on the back side)
Supports TF card for extended storage - Charge indicator
Lights up when charging, off when fully charged - BOOT button
For downloading program or entering boot mode - WS2812 RGB LED (for non-touch version only)
For colorful lighting effects, on the back side - QMI8658 sensor (on the back side)
3-axis gyroscope and 3-axis accelerometer - IPEX1 connector (for touch version only)
Switch to external antenna via onboard resistor - Onboard ceramic antenna
For space saving and signal stability
Dimensions:
WARNING
