2 Relay Wireless Remote Control

2 Relay Wireless Remote Control

Features

• 2 Relay Module with Remote Control.
• Remotely control up to 2 devices up to 200 meters away.
• Two 10 Amp relays rated at 125VAC.
• Extremely easy to set up and use.
• This remote control is perfect for domestic applications such as remote lighting and appliance control, up down control for motorized window shades, electric door entrance access, etc.
• Excellent as a simple wireless remote control for robotics applications.
• The relays can be set to toggle action, momentary or jog action by setting the jumper next to the programming button.
• Multiple relays can be activated to stay on at the same time.

Remote Programming

• Relays corresponding to the A and B buttons are labeled (NO1 COM1 NC1) and (NO2 COM2 NC2).
• When using for the first time the remote has to be programmed.
• After powering the relay module with 12VDC the red Power On LED will stay on:
• Press the black programming button on the relay module next to the LED.
  Push button A once on the remote.
  You will hear a click from the relay and the Program LED will flash 4 times indicating that is has accepted the code for relay A (#1 relay).
  You can check by pressing the A button to toggle the #1 relay ON and OFF.
• Press the programming button on the relay module again and repeat procedure for button B (relay #2).
• The program will be retained even if power is removed from the module.
• To reset the program for both relays hold the programming button down for about 8 seconds until the LED turns off.
• The jumper in position A-Center results in relay toggle action (push to activate, push again to release.
• The jumper in position Center-B results in jog action with A and B push turning alternately ON/OFF
• The jumper removed results in relay momentary action with each button push.

• Number of relays: 2
• Working voltage: DC12V
• Quiescent condition: Less than 6mA
• Working temperature: -40°c+80°c
• Receiver sensitivity: more than -105dBm
• Working frequency: 315mhz
• Output voltage: DC and 125VAC as required
• Relay normal current: 3A
• Max load current: 10A
• Dimensions: 72 x 52 x 26mm

Remote Control

• Number of Buttons: 2
• Remote Range: 200 meters
• Operating Voltage: DC 12V
• Frequency: 315 Mhz
• Operating Current: 13 mAh
• Code Type: Fixed code / Learning code
• Dimensions: 58 x 39 x 14mm