PS-DCDC-15 Buck 15A Adjustable DC to DC Step Down Converter

Price:
US$24.85
PS-DCDC-15
In stock
+
Add to wish list

DC/DC 15A Buck Adjustable 4-32V to 1.2-32V Converter Step Down Module

This light device looks very beefy and for a very good reason. Fifteen amps, just writing the numerical value isn't enough. Works like a traditional step down converter that will change a higher voltage into a lower voltage. Need to run a low volt high current motor, you can do just that with this device.
Comes installed with two isolated heat sinks for the transistors. Also comes with a I/O port for soldering in a fan if needed. On the board itself it comes with a 15amp fuse and screw terminals for input and output voltage.

Specs:

  • Module : 15A synchronous-rectified buck
  • Module Properties: non-isolated step-down module (BUCK)
  • Input voltage: DC4-32V (Limit 36V)
  • Output voltage: DC1.2-32V continuously adjustable
  • Minimum differential pressure input and output: 1V
  • Output current :0-15A 10A long natural cooling, the temperature does not exceed 60 degrees, the peak of up to 20A. Decrease the amount of higher ambient temperatures use.
  • Operating temperature: -40 to +85 degrees
  • Operating Frequency: 150KHz
  • Conversion efficiency: Up to 98% (efficiency and input and output voltage, current, pressure related)
  • Short circuit protection: Yes (limit current 25A) input fuse is 15A
  • Over-temperature protection: Yes (over-temperature automatically reduce the output current)
  • Input Reverse Polarity Protection: None (if required in the input string into the diode)
  • Installation: four 3mm screws
  • Connection: terminals, solderless, V-IN as an input, V-OUT is an output
  • Module dimensions: length 60mm width 51mm height 22mm
  • Applications: This module can be applied to the input voltage is higher than the output voltage of the buck areas, such as batteries, power transformers, DIY adjustable power supply, 24V car T of the power supply, automotive LED lights with power, industrial equipment buck, 12V turn 3.3 V, 12V turn 5V, 24V turn 5V, 24V to 12V and so on.