.jpg)
.jpg)
.jpg)
.jpg)
1929-POLOLU Outil de Crêpage: 0.08-0.5 mm² Capacité, 20-28 AWG
This crimping tool can be used to crimp both male and female versions of our JST connector crimp pins, JR crimp pins, Futaba J crimp pins, and crimp pins for 0.1″ housings onto 20-28 AWG wires to make custom cables. The crimping die has a width of 4 mm, and the tool offers ratcheting action for increased consistency and ease of use.
Note: This crimping tool is 3 mm narrower than our more versatile 0.1-1.0 mm² capacity crimper (1928-POLOLU), and it does not crimp the full extent of the wire barrel on the JR, Futaba J, and 0.1" housing crimp pins(see the picture at the bottom of this page). It still makes a sufficient electrical connection between the crimp pin and the wire conductors, however, and the uncrimped portion of the wire barrel will be fully concealed by the connector housing.
We also have a more versatile, wider (7 mm) crimper (1928-POLOLU) that can additionally crimp Tamiya and mini Tamiya connector crimp pins. Because the more versatile tool is wider, it can crimp the full wire barrel on the 0.1" housing crimp pins rather than just part of the wire barrel.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
