12V LED DUAL DISPLAY TIMER

12V LED DUAL DISPLAY TIMER

This is a dual display timer which can be used to set two timings at a time. It comes with the relay module and does not require any external circuit; the timing directly using buttons on it. This module can be used in timing circuits, stopwatch etc.

Specifications:

• Operating Voltage: 12V
• Relay Current: 20A <1800W
• Display time range: 0-999s, 0-999min, 0-999hr
• Size: 48mm x 29mm

Operating instructions:

• Connect timer using your circuit diagram.
• After the power is turned on, the default is the working interface: there are two sets of time for the user to set. Short press “set” to enter the time setting mode. At this time, the digital tube will flash. Pass “+””-“Set time T1; press again “set” to set time T2; after setting, press short again “set” to save Set the data or wait for the 6S system to automatically save the data.
• Long press "set", enter the parameter setting interface, the default is P0--0, you can set P0 by "+" "-".
• P0--0 means that the timing range in seconds.
• P0--1 indicates that the timing range in minutes.
• P0--2 indicates that the timing range in hours.
• P0 setting is completed, short press "set" to switch to P1, the same method to set P1 (P0: timing range P1: working mode).
• P1--0 mode: after delay T1 time, relay will operate (T1 timing).
• P1--1 mode: after delay T1 time, relay will not operate (T1 timing).
• P1--2 mode: after delay T1 time, relay will operate (T1 timing); after delay T2 time, relay will not operate (T2 timing), end.
• P1--3 mode: after delay T1 time, relay will not operate(T1 timing);after delay T2 time, relay will operate(T2 timing),end.
• P1--4 mode: after delay T1 time, relay will operate(T1 timing);after delay T2 time, relay will not operate(T2 timing),repeat cycling.
• P1--25 mode: after delay T1 time, relay will not operate(T1 timing); after delay T2 time, relay will operate(T2 timing),repeat cycling.
• After setting, press “set” again to save the setting data or wait for the 6S system to automatically save the data.