SENS-VIB-P Piezo Vibration Sensor, High Sensitivity 5V Sensor Module for Arduino

SENS-VIB-P  Piezo Vibration Sensor, High Sensitivity 5V Sensor Module for Arduino

This is a piezoelectric sensor with two optional outputs: ADO-Analog Signal and DO-TTL Level Ceramic Vibration

An analog vibration sensor based on a piezoelectric ceramic sheet has an inverse transformation process that uses piezoelectric ceramics to generate vibration. When the piezoelectric ceramic piece vibrates, an electrical signal is generated.

Special sensor expansion boards are used in combination, and analog ports can be weakly perceived. Vibrating electrical signals enable interactive work related to vibration, such as electronic drum interactions.

ADO output: The analog voltage ceramic vibration sensor is connected to the controller analog terminal A0 according to the program. When the vibration degree is different, observing the output value of the serial port can realize the vibration-related in

SPECIFICATIONS
Voltage: 5V Output signal LED indication.
TTL level output.
TTL output effective signal is high level.
The output control current can reach 1A, and it can be connected with high-power LED lights.
To Analog signal output, according to the greater the vibration intensity, the higher the output voltage.
Vibration amplitude sensitivity can be adjusted by potentiometer.
(Left turn sensitivity is low, Right turn sensitivity is high).
The sensitivity can be adjusted to respond with mouth blowing over the device. . .
The sensitivity is very high! It can also be adjusted by hand tapping for output.

Size: 20.5X20.5 (in millimeters)
Weight: 4.25 (in grams)

Sample Code

   /*
  Piezoelectric-Shock-Tap-Sensor-Vibration-Switch-Module
  made on 05 Jan 2021
  by Amir Mohammad Shojaee @ Electropeak
  Home
*/
#define Dig_pin 7
int Dig_out = LOW;
int Ana_out = 0;
 
void setup() {
   Serial.begin(9600);
}
 
void loop() {
   Dig_out = digitalRead(Dig_pin)*100;
   Ana_out = analogRead(A0);
   Serial.print("Anaolog : ");
   Serial.print(Ana_out);
   Serial.print("       Digital :");
   Serial.println(Dig_out);