STC-1000 110V Digital Controllable Thermostat

STC-1000 110V Digital Controllable Thermostat

This nifty little device can automatically control heating and cooling with its’ integrated P.I.D system. Comes with a 2m sensor that has the right amount of length for you to mount wherever you please. Great for home automation or controlling fans for your computer. Plug straight into your wall socket using our PW17-NONPOLAR cable or straight into your main using a 110v line. Adjust to your tolerance and save the settings, power down the system to save energy when not needed!

Specification:

Front Panel Dimension : L 75 x W 34.5 (mm)

Mounting hole size : L 71 x W 29 (mm)

Voltage: 110VAC

Temperature resolution: 0.1°C

Relay Output Capacity: 10A / 250 VAC, acts like a Normally Open / Normally Closed switch.

Installed alarm for error messages

Power consumption: less than 3W

Adjustable settings

-------------------------------------

Temperature range: -50°C to 99°C [default set to (10.0°C) – function F1]

Difference: 0.3°C – 10.0 °C [default set to (0.5°C) – function F2]

Delay timer: 0 – 10 minutes [default set to 3 minutes – function F3]

Temperature reading calibration: -10.0°C to 10.0°C [default set to (0°C) – function F4]

˟ When cooling indicator lights up terminal block 7 and 8 are connected as a series circuit. When heating indicator lights up terminal block 5 and 6 are connected as a series circuit.

˟ When cooling indicator is flashing it is waiting for delay to end

˟ Hold on power for 3s to power on or off

˟ Hold on S to enter settings F1 – F4

˟ Press S to see Function in detail

˟ Press up or down arrow key and S together to change value, then click power to save the settings. (will automatically reset after 10 seconds of not registering or modifying value)

Project idea:

http://hackaday.com/2014/03/15/temperature-controller-gets-open-source-firmware-upgrade/

• Drink responsibly.