5-24VDC 150mA Magnetic Proximity Sink Switch
This little blue box acts as a switch that has three wires and is normally open. Apply VCC to the brown cable and supply ground to the blue cable, when you move something magnetic over the crosshair printed on the casing of the blue switch the led will light up creating a short circuit. To apply a load simply connect VCC of the component to the brown cable and connect the output to the black wire. The maximum current the load will receive is around 150mA. This device is a switch that will sink voltage to the load to power.
Specifications:
- Voltage: 5-24VDC
- Rated Current: 150mA
- Residual Voltage < 2VDC
- Empty Load Current: 2.5mA @ 24VDC
- Switching Frequency < 1000Hz
- Repeatability < 3%
- Hysteresis: 1-20%
- Operating Temperature: -20 ~ 75°C
- IP Rating: 67
- Features: Reverse Polarity Protection, Short-Circuit and Overload Prevention
- Suitable for Low cost automation
- Range: 1cm for detection @ 9V
- Dimensions: 17x17x33 mm (LxWxH)
WARNING
