BH1750 Light Intensity Sensor Module with Case
This is a BH1750 light intensity sensor module with a 16 bit AD converter built-in which can directly output a digital signal; there is no need for complicated calculations. The board is of compact design and mounted in a case for easy use. The module comes with JST wires and can attach according to the I2C pins. The chip will detect a light source intensity and relay back the information using the I2C protocol. You also have an address to add multiple devices to the I2C line. This device will run at 5v or 3.3v as it has the required resistors to bring down the voltage. This is more accurate and easier to use the version of the simple photoresistor which only outputs a voltage that needs to be calculated in order to obtain meaningful data. With the BH1750 Light Sensor intensity can be directly measured by the luxmeter, without needing to make calculations. The data which is output by this sensor is directly output in Lux (Lx). When objects which are lighted in homogeneous get the 1 lx luminous flux in one square meter , their light intensity is 1lx. Sometimes to take good advantage of the illuminant, you can add a reflector to the illuminant. So that there will be a more luminous flux in some directions and it can increase the illumination of the target surface.
Specifications:
- Working Voltage: 5VDC
- Communication interface: I2C
- Input Light Range: 1-65535 Lx
- The influence of infrared is very small.
- Dimensions: 26mmx28.5mmx26mm
Package includes:
- 1 x Light sensor with case
- 1 x JST(2.54mm) to Jumper(Female) Wires
WARNING
