WAVE-30945, RP2350 CAN Development Board, Based On Raspberry Pi RP2350A Dual-core & Dual-architecture Microcontroller, Onboard XL2515 CAN Controller
RP2350-CAN Development Board
A Pico-like MCU board based on Raspberry Pi RP2350A
Compatible with most Raspberry Pi Pico modules
Board specifications
- RP2350A microcontroller chip designed by Raspberry Pi in the United Kingdom
- Dual-core Arm Cortex-M33 processor and dual-core Hazard 3 RISC-V processor, up to 150 MHz
- 520KB SRAM and 4MB onboard Flash memory
- Onboard XL2515 CAN controller, fully supports CAN V2.0B with communication rate up to 1 Mbps
- Type-C connector for modern and easy connectivity
- Castellated module allows soldering directly to carrier boards
- USB 1.1 with device and host support
- Low-power sleep and dormant modes
- Drag-and-drop programming using mass storage over USB
- 2 × SPI, 2 × I2C, 2 × UART, 4 × 12-bit ADC, 16 × controllable PWM channels
- Accurate on-chip clock and timer
- Temperature sensor
- Accelerated floating-point libraries on-chip
- 12 × Programmable I/O (PIO) state machines for custom peripheral support
C/C++, MicroPython support
Comprehensive SDK, development resources, and tutorials to help you get started easily.
Dual-core, dual-architecture
Features both dual-core Arm Cortex-M33 and dual-core Hazard 3 RISC-V processors with a flexible clock up to 150 MHz.
Onboard XL2515 CAN controller
Fully supports CAN V2.0B, capable of transmitting and receiving standard, extended, and remote frames. Communicates up to 1 Mbps with SIT65HVD230 transceiver.
26 × multi-function GPIO pins
Configurable for flexible development and integration.
What's On Board
- RP2350A – Dual-core, dual-architecture MCU, up to 150 MHz
- P25Q32SH-UXH-IR – 4MB NOR-Flash
- BOOT button
- RESET button
- MP28164 – High-efficiency DC-DC buck-boost chip
- User LED – Not a power indicator
- USB Type-C connector – For programming and USB1.1 host/slave support
- Debug pins
- SIT65HVD230DR – CAN transceiver
- XL2515QF20 – CAN controller
- Terminal resistor selection – Enable/disable 120Ω matching resistor
- CAN screw terminal
- GPIO header – Compatible with Raspberry Pi Pico pin header
Dimensions
WARNING
