WAVE-20891, Pico-like MCU Board Based on Raspberry Pi MCU RP2040, with LCD 0.96" (Pre-soldered header)

The WAVE-20891 is a small MCU board designed for the Raspberry Pi Pico. It uses the RP2040 microcontroller chip and has an onboard 0.96inch IPS display, a Lithium battery recharge/discharge header, and a high-efficiency DC-DC buck-boost chip.

This is a low-cost, high-performance Pico-like MCU board with flexible digital interfaces. It incorporates Raspberry Pi's RP2040 microcontroller chip, as same as the one on Raspberry Pi Pico. For software development, either Raspberry Pi's C/C++ SDK, or the MicroPython is available, which makes it easy for you to get started, and integrate it into end products quickly.

Features

• RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom
• Dual-core Arm Cortex M0+ processor, flexible clock running up to 133 MHz
• 264KB of SRAM, and 2MB of onboard Flash memory
• USB-C connector, keeps it up to date, easier to use
• 0.96inch 160×80 pixels 65K colourful IPS LCD display
• Lithium battery recharge/discharge header, suitable for mobile devices
• Onboard DC-DC chip TPS63000, high-efficiency DC-DC buck-boost chip, 1.8A current switch
• The Castellated module allows soldering directly to carrier boards (there should be a dedicated cut-out for embedding the bottom components)
• USB 1.1 with device and host support
• Low-power sleep and dormant modes
• Drag-and-drop programming using mass storage over USB
• 26 × multi-function GPIO pins
• 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
• Accurate clock and timer on-chip
• Temperature sensor
• Accelerated floating-point libraries on-chip
• 8 × Programmable I/O (PIO) state machines for custom peripheral support

Pinout

Board and Dimensions

Shipping List

Weight: 0.007 kg

1. RP2040-LCD-0.96 with pre-soldered header x1

Wiki: RP2040-LCD-0.96