WAVE-29307, Nano Base Board (A) for Raspberry Pi Compute Module 5
Nano Base Board (A) for CM5
Suitable For Evaluating The Raspberry Pi CM5 Or Being Integrated Into End Products
Same Size As The CM5
Compact size and fully functional, With Multiple Peripheral Interfaces, Suitable for Narrow Application Environments
Note: CM5 not included.
Specifications
CM5 SOCKET: Suitable for all variants of Compute Module 5
CONNECTOR: Raspberry Pi 40PIN GPIO interface × 1
USB: USB 3.2 Gen1 Type A port × 1
MIPI: MIPI 4-lane interface × 2 (22pin 0.5mm FPC connector)
STORAGE: TF card socket for Compute Module 5 Lite (without eMMC) variants
POWER INPUT: 5V
DIMENSIONS: 55 × 40mm
What's On Board
- CM5 socket
suitable for all variants of Compute Module 5 - USB port
USB 3.2 Gen1 high speed interface, for connecting sorts of USB devices - TF card slot
for connecting a TF card with pre-burnt image (Lite variant ONLY) - Power supply / Programming
5V power supply, or used for eMMC burning - FAN header
4PIN JST-SH PWM fan header for connecting a cooling fan - PSW button
power button - BOOT button
Press before powering on and release after powering on to enter the burning mode
- 2PIN JST-SH RTC battery header
- 40PIN GPIO interface
suitable for connecting to various HAT modules - Dual MIPI interfaces
for connecting to DSI displays or CSI cameras - Special function pins
CM5 core power enable and ETH SYNC signal - IO-VREF selection
CM5 IO logic level: 3.3V or 1.8V - Function enable pins
Enabled by default, can be disabled by shorting the corresponding pads - Dual-color LED indicator
Red light: Raspberry Pi power indicator
Green light: Raspberry Pi working status indicator
Dimensions
WARNING
