Shop Our Brands

WAVE-147 CC Debugger, LPC Debuggers & Programmers

Manufacturer: Waveshare
Prix:
US$46.19
WAVE-147
In stock
+ −
Ajouter à la liste de souhaits

WAVE-147 CC Debugger, LPC Debuggers & Programmers

Le débogueur CC est principalement utilisé pour le débogage et la programmation de la mémoire flash sur les périphériques System-on-Chip (SoC) basés sur CCxxxx 8051 de Texas Instruments. Le débogueur CC prend également en charge les émetteurs-récepteurs RF CCxxxx. De plus, CC Debugger est utilisé pour configurer les périphériques CC85xx avec le configurateur sans fil PurePath.

Key Features

  • Performance
    • Compatible with the original TI CC Debugger
    • Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
    • Target voltage: 1.2V～3.6V
    • Capable of powering the target board from the debugger
    • Operating temperature: 0℃～85℃
  • Supported Software
    • IAR Embedded Workbench For C8051
    • SmartRF Flash Programmer
    • SmartRF Studio
    • SmartRF Packet Sniffer
    • PurePath Wireless Configurator
  • Connects to PC
    • Computer connection via USB interface
  • Connects to target board
    • Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:

Supported Devices

  • Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
    • CC1110, CC1111
    • CC2430, CC2431
    • CC2510, CC2511
    • CC2530, CC2531, CC2533
    • CC2540, CC2541
    • CC2543, CC2544, CC2545
  • Controlling the following transceivers from SmartRF Studio:
    • CC1120, CC1121, CC1125, CC1175
    • CC1101, CC110L, CC113L, CC115L
    • CC2520
  • Configuring the CC85xx devices with PurePath Wireless Configurator:
    • CC8520, CC8521
    • CC8530, CC8531

LED Status

  • OFF: The debugger has no power or there is no valid firmware on the debugger.
  • AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
  • RED LED BLINKING: The Debugger is in Boot Recovery Mode.
  • RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
  • GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.

Downloads

Development resources:user manual, schematic, firmware, software, etc.

Wiki: www.waveshare.com/wiki/CC_Debugger

Avis destiné aux résidents de Californie uniquement: Warning symbolWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov