Olimex Development Prototype Board for 40 Pin PIC Microcontrollers
With this board you can develop and prototype with all Microchip's PDIP40 PIC microcontrollers. The RS232 driver on board allows an easy connection with a PC or other embedded hardware. The board has a user button and status LED. The bridge rectifier allows the board to be powered with both AC and DC power supply adapters. PIC-P40 supports both 3V low power and normal 5V operation.
FEATURES
- ICSP/ICD connector with 0.100'' spacing for programming or debugging
- RS232 Tx, Rx interface with MAX232 IC on socket
- PDIP40 microcontroller socket
- Quartz crystal 20Mhz
- LED to RA0 through jumper
- User button on RE2 port
- Reset button
- Power plug-in jack
- Selectable +3.3V / +5V power supply voltage regulator
- Extension slot for every uC pin
- Grid with 100 mils step
- GND bus
- Vcc bus
- Four mounting holes 3,3 mm (0,13")
- FR-4, 1.5 mm (0,062"), red solder mask, white silkscreen component print
- Dimensions 100x80 mm (3,9x3,15")
SCHEMATIC:
WARNING
