Our Brands

Quadcopters

1 2 3 4 5 6 7 8 9
Newest Items First
15 Per Page
D-CON-01 3.5mm Gold Bullet Connector Plug
US$1.11
It is a pair of male and female 3.5mm Bullet Connectors also known as Banana Connectors. These Connectors are great for attaching motor signal connections to the ESCs. Motors such as the EMX-FPV-01 that have medium wires require a medium bullet connector such as this one to allow users to easily switch motors from ESCs or change directions of the motor spinning.
In stock
+ −
Add to wish list
D-ANT-02 5.8 GHz Right Angled Circular Polarized Antenna RX/TX Set
US$19.95
An Antenna Set that is commonly used for First Person Video at 5.8 GHz, it comes with a RX and TX antenna. What makes this antenna widely used is the configuration of the antenna itself. Casting and receiving in Omni-directions all 5.8 GHz channel frequencies the antenna is protected in a plastic casing offering quality and range. It has the RP-SMA male connectors at an angle offering different mounting capabilities.
In stock
+ −
Add to wish list
BAT-T-10 LiPo Battery Tester & Low Voltage Buzzer 1S to 8S
US$11.19
If you ever wanted to find out what the voltage was on your LiPo battery, this little device can measure the voltage and readout the value to indicate when the voltage for a cell is past a setting that you may have set it to. LiPo batteries are happy around 3.7v to 3.2v any lower and it can often never recharge again, any higher and it could be affected by reducing the lifespan of the battery. The speaker will sound when the voltage is too low, offering a reminder to charge the battery.
In stock
+ −
Add to wish list
EMX-FPV-02 EMAX Multirotor Motor MT2213 935kV CW
US$25.13
This motor will spin Clockwise and the motor shaft is inserted counter clockwise. It has a nice metallic body that allows it to dissipate any heat buildup. Comes with the required screws and motor mount in a beautiful foam padding. The specs on the side of the box offers a reminder when storing or opening for the first time what speed the motors run at. Motors are pre-soldered with bullet connector.
In stock
+ −
Add to wish list
EMX-FPV-01 EMAX Multirotor Motor MT2213 935kV CCW
US$25.13
This motor will spin Counter Clockwise and the motor shaft is inserted clockwise. It has a nice metallic body that allows it to dissipate any heat buildup. Comes with the required screws and motor mount in a beautiful foam padding. The specs on the side of the box offers a reminder when storing or opening for the first time what speed the motors run at. Motors are pre-soldered with bullet connector.
In stock
+ −
Add to wish list
BAT-T-20 3-cell LiPo battery low-voltage alarm
US$6.65
Those small modules are made to prevent Lithium-Polymer (LiPo) batteries to lose too much power and get damaged. Six LEDs show you which battery has enough charge and which don’t, and a loud (95dB) alarm starts as soon as one of the batteries attached gets under 3.3V.
In stock
+ −
Add to wish list
EMX-AC-1087 8mm Bullet Connectors
US$2.45
These connectors are constructed from the highest quality materials to ensure you get the best connection every time, whatever your application. This package includes one pair (male and female) of these heavy-duty connectors. They are able to accommodate heavy-duty 8AWG wire and are rated to handle up to 300 amps of current.
In stock
+ −
Add to wish list
EMX-SC-0101 EMAX 30A ESC / Linear BEC with BLHeli firmware 2-4S
US$22.39
This ESC/BEC has a low-voltage, overheat, throttle and signal loss protection integrated. These ESCs do not come with bullet connectors soldered on the wires. We recommend purchasing some heat shrink and bullet connectors that will allow you to replace your ESC or change motors when you want. Using BLHeli suite you can reprogram the ESCs on the computer using a Arduino nano.
In stock
+ −
Add to wish list
EMX-SC-0099 EMAX 20A ESC / Linear BEC with BLHeli firmware 2-4S
US$16.73
This ESC has a built in linear BEC that has low-voltage protection, over-heat protection, throttle and signal loss protection integrated. These ESC do not come with bullet connectors soldered on, we recommend purchasing some with heat shrink for secure and nonconductive connections. This ESC supports OneShot125 offering better and faster brake times.
In stock
+ −
Add to wish list
EMX-AC-1517 OpenPilot CC3D Atom 32-Bit Flight Controller with bent pins
US$33.53
The CC3D boards are an all-in-one stabilization hardware which runs the OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the OpenPilot Ground Control Station (GCS) software. The retail CC3D Atom board comes with the CC3D Atom board, an assortment of wires to connect to the Flexi port, main port and Flexi I/O port.
In stock
+ −
Add to wish list
EMX-MP-0143 5x3 5030 GWS Carbon fiber Propellers (CW, CCW) Set
US$9.73
Accidently crashed your quadcopter, want to build your own custom copter and you are looking for a 5 inch propeller diameter and a pitch of 3 inch? This product can help you replace blades resulting in multiple crashes and draws less current than a standard blade.  
In stock
+ −
Add to wish list
EMX-AC-0270 NightHawk 250 II Carbon Fiber Replacement Screw Pack
US$6.93
If you accidently stripped the screws or broke some standoffs, we offer a package of replacement pieces if needed. If in case you crash your drone and order a replacement bottom frame you are required to salvage from the crash the screws, spacers and nuts to reassemble the quad. This package will offer the required nuts spacers and screws replacements all neatly packaged within a small plastic resealable bag.  
In stock
+ −
Add to wish list
EMX-AC-1615 NightHawk 250 II Carbon Fiber – Bottom Board Replacement
US$15.33
If you have accidently crashed your NightHawk 250 II Carbon Fiber we could recommend purchasing this replacement part to fix your drone. This board is comprised of acrylic with carbon fiber layer resulting in a lightweight frame. Attached your ESC to this board to save space.
In stock
+ −
Add to wish list
EMX-AC-1614 NightHawk 250 II Carbon Fiber – Middle Board Replacement
US$24.99
If you have accidently crashed your NightHawk 250 II Carbon Fiber we could recommend purchasing this replacement part to fix your drone. This board is comprised of acrylic with carbon fiber layer resulting in a lightweight frame.
In stock
+ −
Add to wish list
EMX-AC-1613 NightHawk 250 II Carbon Fiber – Top Board Replacement
US$15.33
If you have accidently crashed your NightHawk 250 II Carbon Fiber we could recommend purchasing this replacement part to fix your drone. This board is comprised of acrylic with carbon fiber layer resulting in a lightweight frame.
In stock
+ −
Add to wish list
1 2 3 4 5 6 7 8 9