RC Models Signal Loss Alarm Module

RC Models Signal Loss Alarm Module

Signal loss Alarm & Lost Plane Finder, a simple device that plugs into any servo/Rx port, will detect the loss of Tx signal and emit a loud 85dB alarm. It is Ideal for warning you if you have not turned off your Rx power supply while in the pits, or if you are having trouble finding a model in the long grass, simply turn off your TX and within a minute, the alarm will sound!

Instructions:

1. Connect the alarm between the servo and the receiver, i.e. act as a servo extension cord.
2. Turn on your TX. and you will hear 2 x beep sound.
3. Do not move any of the control stick on the TX or simply turn off the TX. You will hear a continuous beep sound after 1 minute. It will stop once you turn on your TX or move the control stick.
4. If you ignore the continuous beep sound for around 2 minutes, the beep sound will change tp a Louder sound.
5. You need to disconnect the alarm from the receiver in order to switch off the alarm.
6. MAKE SURE THE CORRECT POLARITY BEFORE TURN ON THE TX.

Specifications:

• Mode: GC/LMA
• Size: 17*13*10mm
• Weight: 4.5g
• Operating Voltage: 4V-6VDC
• Current Drain: 1-35mAh