Opto/Illumination

US$20.92

The product kit comes with: A fully tested and assembled 1.2" LED backpack. Ultra-bright 1.2" 8x8 red matrix. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. 

In stock
+
Add to wish list

US$21.88

The product kit comes with: A fully tested and assembled 1.2" LED backpack. Ultra-bright 1.2" 8x8 green matrix. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. 

In stock
+
Add to wish list

US$30.63

The product kit comes with: A fully tested and assembled 1.2" LED backpack. Ultra-bright 1.2" 8x8 blue matrix. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. 

In stock
+
Add to wish list

US$3.07
6" (150mm) long jumper cable of 6 conductors, 0.1" spacing with two 'female'/sockets on either end. Great for wiring up ShiftBrites together!
In stock
+
Add to wish list

US$6.92
The LED is very bright, with 90 Lumens in a 140 degree lambertian pattern.
In stock
+
Add to wish list

US$7.00
Pack of 25 diffused red LEDs. 5mm diameter. 660 nm wavelength. 1.85-2.5V Forward Voltage, at 20mA current. 250 mcd typical brightness. 
In stock
+
Add to wish list

US$13.92
Make a scrolling sign, or a small video display with this 8x8 gridded bi-color LED matrix. Only 1.2" on a side, it is quite visible but not so large it wont plug into a breadboard!
In stock
+
Add to wish list

US$8.67
When powered, the LEDs perform a slow fade through the rainbow, from red to orange to yellow, etc till they get back to red.
In stock
+
Add to wish list

US$7.88
There are 16 pins on the side, 8 on each, with 0.1" spacing so you can easily plug it into a breadboard with one row on each side for wiring it up.
In stock
+
Add to wish list

US$8.67
They are fairly bright so they can be seen in daytime, and from any angle. They go easily into a breadboard and will add that extra zing to your project.
In stock
+
Add to wish list

US$4.38
They allow connecting of two sets of four wires together using just a flat-head screwdriver.
In stock
+
Add to wish list

US$13.93
There are 16 pins on the side, 8 on each, with 0.1" spacing so you can easily plug it into a breadboard with one row on each side for wiring it up.
In stock
+
Add to wish list

US$8.67
Each strand comes with 12 LEDs, approximately 5cm/2 inches apart for a 2 foot long strand of wire. At one end of the magnet wire, a double stranded-core wire is soldered on and heat-shrinked to protect it.
In stock
+
Add to wish list

US$20.92

The product kit comes with: A fully tested and assembled 1.2" LED backpack. Ultra-bright 1.2" 8x8 yellow/orange matrix. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. 

Delivery within 2-3 weeks
+
Add to wish list

US$3.50
Clear 5mm tri-color LEDs with separate red, green and blue LED chips inside!
Delivery within 2-3 weeks
+
Add to wish list