LED-10MWPCW-24V, COOL WHITE 24VDC 2835SMD Non Addressable Waterproof LED Light Strip (10 Meters, 12mm wide)

LED-10MWPCW-24V, COOL WHITE 24VDC 2835SMD Non Addressable Waterproof LED Light Strip (10 Meters, 12mm wide)

This is a 10 meter cool white 6500K LED-STRIP WS2835 which is waterproof and provides a running water flow effect.

Features:

• Use super brightness LED as light source.
• Flexible and can be fixed on uneven surface, small volume, available in many colors.
• Each three LEDs make a loop and can be cut accoring to the incising line, without damaging other parts.
• Low power supply, safe for use.
• Long life span 50,000+ hours
• Can be used for illumination around transparent or non-transparent material.
• There is a 10M double side adhesive on the back for pasting.
• IP Grade: IP67 - Waterproof

Specifications:

• View angle: 120 degrees
• Working Voltage: 24V DC
• Total Width: 12mm (Note this is including the waterproof material around the strip)
• LED Quantity: 120 bead LEDs/M
• Working Current per meter: 0.5A
• Output power: 12W/meter
• Storage Temperature: -40 degrees celsius to 80 degrees celsius
• Operating Temperature: -25 degrees to 60 degrees celsius
• Luminous Flux: 15-18 Lumens/LED
• Color Temperature: Cool White 6500K

To get started:

You will need the following components

• 10m LED Strip (Included)
• Power supply: Wall Adapter 24V 2A - 2.5mm (sold separately) ABRA#:DC-24V2A
• Female DC power adapter - 2.1 jack to screw terminal block (sold separately) ABRA#: 368-ADA
• A WS2835 controller, Wireless RF Touch Controller for WS2835 24V DC Water flow effect LED Strip (sold separately) 

Connection is easy. The LED strip comes with two bare wires already attached to it. Connect the bare wires to the 368-ADA screw terminal, which in turn connects to our DC-24V2A (24V power supply). See the Connection diagram below.

And now, with the pre-programmed Wireless RF Touch Controller, connect the female JST-SM connector to the male JST-SM connector of the LED Strip on the other end. Once that's complete, you can power on the LED Strip by connecting the power adapter to the power outlet. Also, with the remote included in the package, you can manipulate the LED strip. See diagram below for visual representation of JST-SM CONNECTION via RF controller and LED Strip. Also, an example of visual connection of the entire set has been provided below for comparison purposes. Please note that the LED light strip is 10 meters long while this image only shows a part of it.