RGBW Waterproof (5050) LED 12VDC Flexible Strip 5M, RGB and Warm White
This led strip is great for mounting on any smooth surface for any festive occasions or projects, it’s composed of 50x50 mm RGBW LEDs. We would recommend a 12V power supply with atleast 2A and an IR Receiver and Transmitter to colour ranges desired without programming knowledge. The jumpers are removable for the connector of the LED strips allowing you to change which end you want to supply power. It is for waterproofing and has 3M adhesives on the back, you can cut the strip and reattach the strip by soldering cables. This unit contains analog-only RGBW LEDs and does not have the ability to control the LEDs individually, ensure that the black cable supplies VCC only.
Specifics
- RGBW 5050
- Viewing angle: 120°
- Voltage: 12V
- LED Quantity: 60/m x 5m = 300 leds/5m
- Operating Temperature: 20ºC to 50ºC
- Lumens: 800-900 Lumens/meter
- Dimensions: 500 x 1 x .2 cm (L x W x D)
How to get started:
Using a pre-programmed controller ABRA#: LED-STRIP-WIFI-5P, SOLD SEPERATELY, connect it to the LED strip. Using a recommended power supply of 12V 2A as mentioned above, you can light up the LED strip, enjoy the view and set the colours by using the remote controller.
Below is a sample connection diagram that consists of the LED Strip, LED pre-programmed controller that goes by ABRA# LED-STRIP-WIFI-5P and finally the power supply of 12V and 3A that goes by ABRA# DC-1203-2.1. The second image, you will notice that the black wire is connected in the triangle port. The reason being is that the black wire comes from the 12VDC of the LED STRIP. Whereas the blue, red, green and white wires are colour coded for their respective colours RGBW and appropiately connected once the triangle labeled port is connected to the 12V black wire.
Connection Diagrams
WARNING
