12-24VDC 6A PIR Motion Sensor Switch for LED Strips
Don't we all love functionality and simplicity when it comes to electronics? Well this device has it all! It is the equivalent of the fancy equipment you may find in motion sensing lamp posts that turn on the light whenever they sens somebody passing by and off when no one is around to save energy. The difference here that it is capable of turning LED strips instead.
To use this device, plug your led Strip FIRST into the male OUT port 2.5mm barrel Jack connector and then your power source male 2.5mm barrel jack into the IN port.
Specifications:
Working temperature: -20 to +60 Degrees C.
Input Voltage: 5-24VDC.
Induction sensing distance: 8M
Angle: 60 degrees
Output current: <6A
Delay Time: fixed
Note:
1.Dont expose the device to direct sun light or bright lighting, wind, or put it near a heater or an air conditioner.
2.Dont fix it at a place where there are obstructing materials (eg. Glass, dense clothes) which IR cannot get though.
3.Dont fix it in strong shock or vibration environment.
4.The PIR Sensor requires a "warm-up time" in order to function properly, about 10s to 1 min maximum,depend on the delay time; during this time, the signal triggered by the module is not stable, after one minute, it will be ready.
5.The sensitivity of this device is not uniform all around, please make sure you adjust the position accordingly after its warm up time.
WARNING
