2000-0025-0004, (25-4, Super Speed) 2000 Series Dual Mode Servo Motor
Meet the Dual Mode ‘SUPER SPEED’ Servo. This servo is essentially an even faster version of the 2000-0025-0003 ‘SPEED’ Servo, reaching speeds of up to 290RPM! Just like the 25-2 and 25-3, this servo boasts two different modes:
Default Mode
In Default Mode the servo is able to rotate while having positioning feedback. In this mode, the PWM signal will determine the position of the servo.
Continuous Rotation Mode
Using the 3102 Series Dual Mode Servo Programmer (1-1) the servo can be toggled into continuous rotation mode. In this mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
How Far Will This Servo Rotate in Default Mode?
The rotation range depends on your control system:
- With an average radio system: 135° — limited PWM range.
- Radio system + Travel Tuner: 300° — wider PWM range when used with a Servo Travel Tuner.
- Wide signal controllers: 300° — systems like Servo Commander, Arduino, and Raspberry Pi servo hats usually send a wide signal.
Specs
| Weight | 58g (2.05oz) |
|---|---|
| Gear Ratio | 67:1 |
| Output Shaft Style | H25T Spline |
| Voltage Range | 4.8V - 7.4V |
| No-Load Speed (4.8V) | 0.055 sec/60° (180RPM) |
| No-Load Speed (6.0V) | 0.043 sec/60° (230RPM) |
| No-Load Speed (7.4V) | 0.035 sec/60° (290RPM) |
| Stall Torque (4.8V) | 55 oz-in (4.0 kg.cm) |
| Stall Torque (6.0V) | 65 oz-in (4.7 kg.cm) |
| Stall Torque (7.4V) | 75 oz-in (5.4 kg.cm) |
| No-Load Current (4.8V) | 190mA |
| No-Load Current (6.0V) | 200mA |
| No-Load Current (7.4V) | 230mA |
| Stall Current (4.8V) | 2,000mA |
| Stall Current (6.0V) | 2,500mA |
| Stall Current (7.4V) | 3,000mA |
| Max PWM Range | 500-2500μsec |
| Max PWM Range (Continuous) | 1000 - 2000μsec |
| Travel per μsec | 0.15°/μsec |
| Max Rotation (Default Mode) | 300° |
| Pulse Amplitude | 3-5V |
| Deadband Width | 4μsec |
| Motor Type | Brushed DC |
| Feedback Style | 5KΩ Potentiometer |
| Output Shaft Support | Dual Ball Bearing |
| Gear Material | Steel |
| Wire Length | 11.81" (300mm) |
| Wire Gauge | 22AWG |
| Connector Type | 3-Pos TJC8 Servo Connector [MH-FC] |
| Servo Size | Standard |
| Direction with Increasing PWM Signal | Clockwise |
