WAVE-30952, ARGON ONE V5 Case For Raspberry Pi 5, Dual M.2 NVMe PCIe Slots, Compatible With Standard Raspberry Pi HATs
Dual M.2 NVMe PCIe Slots
Aluminum Alloy Case for Raspberry Pi 5
Built-in Cooling Fan, Designed For Raspberry Pi 5
* For reference only. Raspberry Pi 5 and M.2 NVMe drive are NOT included.
Features
- Aluminum alloy case for efficient heat dissipation performance
- Built-in 30mm PWM fan for active thermal control during intense workloads
- Dual HDMI ports for high-resolution dual-display support
- Two additional front-facing USB 2.0 ports for convenient peripheral access
- Built-in DAC with 3.5mm mic input & headphone output jack for enhanced audio
- Dual NVMe PCIe slots (PCIe Gen 2.0, 500MB/s per channel) for high-speed storage
- Compatible with standard Raspberry Pi HATs for expansion
Interface Description
Dual M.2 NVMe Expansion Board Compatibility
| Compatible NVMe Drives |
|---|
| Waveshare NX-NVME 2280 SSD |
| Official Raspberry Pi SSD |
| Western Digital SN850 |
| Western Digital SN740 |
| Western Digital SN570 |
| Western Digital SN530 |
| Western Digital Black SN750 SE (Phison Controller) |
| WD Blue SN580 NVME |
| Samsung 980 Pro |
| Samsung 980 |
| Sabrent Rocket Nano |
| Sabrent Rocket 4.0 |
| PNY CS1030 |
| Origin Inception TLC830 Pro NVMe |
| Netac NV3000 NVMe SSD |
| Netac NV2000 NVMe SSD |
| Lexar NM710 |
| Lexar NM620 |
| Kioxia Exceria NVMe SSD |
| Kioxia Exceria G2 NVMe SSD |
| Kingston KC3000 |
| Kingston SNV2S NV2 Gen4 PCIe NVMe M.2 2280 |
| Inland PCIe NVMe SSD |
| Crucial P2 M.2 |
| Axe Memory Generic Drive |
| AData XPG SX8200 Pro |
Note: Drives listed above are tested for compatibility. Other models may also work but are unverified.
Assembly Instructions
Prepare the accessories as shown above.
1. Connect Raspberry Pi 5 to HDMI-USB2-Audio Board, apply thermal pads ⑤ as shown.
2. Route PWM fan and NVMe power cables through the rear guide posts.
3. Mount Raspberry Pi 5 and board into case and secure with 4x ② screws.
4. Install NVMe drives in the slots and apply blue thermal pads ⑥.
5. Fix middle and bottom case with 4x ① screws, attach anti-slip pads ④ to corners.
6. Connect PCIe cable ③ to NVMe board and Raspberry Pi 5. Copper side must face white PCIe port side.
7. Connect NVMe power cable to its designated port.
8. Connect cooling fan power cable to Raspberry Pi 5 FAN port.
9. Attach the top cover and secure with 2x ② screws to complete assembly.
* For reference only. Please refer to the package content for the part list.
Outline Dimensions
