L6201, Single 1 Amp 48 Volt DC Motor Driver for 5v Microcontrollers
This is a motor driver that can be interfaced with an Arduino microcontroller or any 3.3v-5v based microcontroller. This motor driver module can handle up to 48 volts and handle a maximum of 1 amp of current. (sufficient cooling is required to pull out 2 amp.) This motor driver is based on the L6201, which is a full bridge drive controller board allowing for backwards and forwards motion which is similar to the L298N.
Specifications:
- Operating Voltage: 7.2-30VDC
- Maximum Current Handle: 1 Amp without additional heatsink
- Wattage: 20Watts
- PWM controllable to vary speed of the motor
- Dimensions: 29.5x52.2mm (L x W)
WARNING
