This is the D4184 Isolated 3-5V MOSFET field effect tube module.
Specifications
1. With optocoupler isolation, the control signal and the power of the controlled device are isolated, which greatly increases the rigidity of the interference.
2. Compatible with MCU and Arduino control board, 3V or 5V signal
3. High level start, low level stop, PWM speed regulation
4. Widely used to control the start and stop of the motor, solenoid valve and other tributary equipment
5. There are various specifications of available MOS tube modules which provide other choices:
FR120N : 100V 9.4A
LR7843 : 30V 161A
D4184 : 40V 50A
6. The signal input side can be soldered to the terminal or pin itself, on a compatible breadboard.
7. Output can be soldered to the terminal or direct wire
8. Module size 33mm X 16mm.
There are two 2mm diameter non-plated screw holes with 8mm spacing.
Comes with:
1 x 3-pin terminal block
1 x 2-pin terminal block
1 x 3-pin male header
WARNING
