Electromechanical

US$6.94

The Pololu basic relay carrier modules allow simple control of a single-pole, double-throw (SPDT) switch from low-voltage, low-current control signals.

In stock
+
Add to wish list

US$6.94

The Pololu basic relay carrier modules allow simple control of a single-pole, double-throw (SPDT) switch from low-voltage, low-current control signals.

In stock
+
Add to wish list

US$10.42
This button is a momentary push button, when you press it the 'normally-open' contact shorts to the common contact. When you release it, the contacts open up again. The switch and LED are separated, so you could wire it to turn on when pressed or vice versa or whatever you wish!
In stock
+
Add to wish list

US$10.42
This button is an on/off switch button, when you press it the 'normally-open' contact shorts to the common contact and the button stays 'pressed'. When you press it a second time, the button springs open, and the contacts open up again. 
Delivery within 2-3 weeks
+
Add to wish list

US$10.42
This button is a momentary push button, when you press it the 'normally-open' contact shorts to the common contact. When you release it, the contacts open up again. The switch and LED are separated, so you could wire it to turn on when pressed or vice versa or whatever you wish!
In stock
+
Add to wish list

US$10.42
These chrome-plated metal buttons are rugged and waterproof and look real good while doing it! Simply drill a 16mm hole into any material up to 1/2" thick and you can fit these in place, there's even a rubber gasket to keep any water out of the enclosure.
In stock
+
Add to wish list

US$10.42
This button is an on/off switch button, when you press it the 'normally-open' contact shorts to the common contact and the button stays 'pressed'. When you press it a second time, the button springs open, and the contacts open up again. 
In stock
+
Add to wish list

US$5.17
This microswitch has a 3" long wire lever actuator and three terminals. Sometimes called 'coin switches' - they're used in coin detectors. The terminals are along the bottom (the other microswitches have them on the sides).
In stock
+
Add to wish list

US$3.76
This microswitch has a flat metal lever actuator and a roller at the end. The roller makes it a little better for angled actuation. This switch comes with three terminals (common/normally-open/normally-closed). We also have kinds with a bump actuator, flat lever and long wire.
In stock
+
Add to wish list

US$9.54
Quick connector wire sets will make wiring up our arcade-style or metal waterproof buttons quicky-quick. Each wire comes as a 'pair' with two 0.11" quick-connects pre-crimped onto 20cm long wires.
In stock
+
Add to wish list

US$13.13
This foot switch is made of rubbery plastic, is plenty strong to put up with any amount of stomping, and contains a snap switch. You can use the switch as either a "normally open" or "normally closed" type. Attached to the switch is a 2 meter long cable so you can wire it directly to your project.
In stock
+
Add to wish list

US$2.63
This electret capsule microphone is the same one we use in our great microphone amplifier board. It contains a small vibrating element that will output a few milllivolts peak-to-peak.
In stock
+
Add to wish list

US$3.42
Stretch out your servo connections with this flexible servo extension cord. It has a 3 pin shrouded "male" connection to plug your servo into and then, 30cm later, a 3 pin female connection. It even keeps the common red/black/white color coding.
In stock
+
Add to wish list

US$8.67
Features: Pack contains four 6" pieces of the following sizes: 3/32", 1/8", 3/16", 1/4", 3/8", 1/2". 2:1 shrink ratio. High-grade flexible polyolefin material. UL approved.
In stock
+
Add to wish list

US$5.68
This navigation switch is an intuitive way to add 5 button's worth of interfacing with a single component. Inside is 5 switches: left, right, up, down and 'select' (pressing down), all with a common ground pin.
In stock
+
Add to wish list