L298P Motor Shield for Arduino Uno and Mega 2650 with Bluetooth
L298 2Amp Motor Driver Shield for Arduino is based on L298 motor driver integrated circuit, a full- bridge motor driver. It can drive two separate 2A DC motors or 1 2A step motor. Motor's velocity and directions can be controlled separately and also there are 6 connectors connected to Arduino analogue pins. This motor driver shield with PWM speed control mode and the PLL mode, using a jumper to switch. This also has a Bluetooth interface where you can directly attach Bluetooth module to the shield. For more details, refer to the manual attached.
Specifications:
- Input voltage: 5V
- Onboard buzzer (D4), can set the astern alarm ringtone.
- It has six digital interfaces that are not occupied(including D2 , D3 , D5 , D6 , D7 , D9)
- It has six analogue interfaces(A0, A1, A2, A3, A4, A5)
- It has an indicator for forward and backwards changing direction.
Difference Between MOT-L298S and MOT-L298P
- L298P has Buzzer and Bluetooth interface which L298S does not have.
- the core chip of both shields is the same L298. the datasheet is included in the attachments.
WARNING
