This is a 160 Watt dual channel DC motor driver 12~24V at 7 Amperes using a half bridge L298, logic control signal Optocoupler PWM with reverse braking.
Product
Double H bridge which could drive two DC motors at the same time, single 7A current, high power;
Wide voltage input:6.5V-27V
Signal optocoupler isolation input, with isolation and undervoltage protection and suit for EMC specifications for electromagnetic compatibility.
It is an electrostatic discharge circuit and stable and reliable, industrial grade.
Product Parameters
Dual motor interface, each rated output current 7A, peak current 50A, the motor interface must not short-circuit, the proposed series is a 10A fuse.
Power supply voltage 6.5V-27V, power supply must not be connected to or over 27V, otherwise it may burn out the module, it is recommended that the power input in series be a 15A fuse.
Working temperature -25 ° -80 °.
Enable signal terminal (ENA) input PWM adjustable speed, PWM frequency range 0-10KHZ, PWM minimum pulse width 10us.
Product size: 55 * 55 * 16mm (length and width).
Control signal voltage 3-6.5V, respectively, is the enable signal and the positive inversion control signal.
Installation hole diameter: 3mm, you can add insulation pad or raise the circuit board height above any surface to prevent a short circuit.
WARNING
