Four Tactile PushButton Breakout Board

In stock
Add to wish list

This is a small board with four tactile pushbutton pre-soldered and ready to connect to any project you have in mind. 

This tiny board has a five male pin headers for connecting female headers and interfacing with your microcontroller of choice. You have 8 pads or 4 sets of 2 pads on the board, simply connect your signal pin to any of the male headers labelled K1 to K4 and ground to GND. The pads have label for each set from C1-C4. The pads in the set nearest to the label are connected to GND. 

You can short the pads via soldering to make a pushbutton that connects to ground when pressed, or add intermediate components between the pads.  

Notice for California Residents: Warning symbolWARNING: Cancer and Reproductive Harm -