KSD9700 series 100° Normally Closed Thermostat Thermal Protector Fuse Temperature Switch 5A 250V
A temperature switch or thermal switch is used to open and close switch contacts. The switching status of the temperature switch changes depending on the input temperature. This function is used as protection against overheating or overcooling. Structure and application:
The KSD9700 series is a kind of thermostat which adopt the bimetal disc as the temperature sensing element. The bimetal disc is in free state and the contacts are closed when the electrical appliance is working in normal condition. When the ambient temperature raises to the preset operating temperature, the contacts open as the bimetal disc deforms to jump when being heated, then the circuit is cut off to control the temperature .Then the contacts will close automatically to cut on the circuit when the electrical appliance is cooled down to the reset temperature. This product is widely used in home appliance’s motor and electrical equipment, such as air conditioner motor, transformer, thermal appliances, etc.
Specifications
Rated Voltage: AC250V 50～60Hz
Rated Current: 5A of Resistive Load
Switch Type and Number of poles: 1 pole opener
IP-Protection Degree: IP00
Action Type: 1A
Operation Cycles: 10000 cycle
Insulation material PTI value:175V
Resistance of Contact:≤50mΩ(original state)
Resistance of Insulated:>100MΩ(DC500V normality)
Test Voltage : ≥ 1250V/1min(nomality)
1 or 2 Temperature Control Switch
Model : KSD9700
Material : Metal case
Contact : NC(Normal Closed)/NO(Normal Open)
Temperature : 15°C~155°C
Rated Power : 250V 5A
Lead Wire Length : 7.3cm / 2.9"
Head Dimension : 20 x 7.5 x 3.5mm/0.78" x 0.3" x 0.14"(L*W*T)
Precautions for use:
1. Do not deform or collapse the casing during installation!
2, this product is not suitable for use in the air temperature, only for contact temperature!
(Can be fixed by tie wire, iron wire, fixing seat or 704 silicone rubber)
3, the metal case is charged, not suitable for working in water.
The plastic case should not be immersed in the insulating seal when it is placed in the water.
4. When the product is installed, the temperature control switch should be close to the mounting surface of the controlled appliance.
WARNING
