1 Amp Breadboard Power Supply DIY KIt module – 9, 5 and 3 VDC Dual Rail Output
This kit contains all the components for making your very own breadboard-friendly power supply. This is a project kit so all the components need to be soldered to the included PCB.
The function of this board is to act as a voltage regulator that can be plugged onto any breadboard that has power rails on both sides. Supply a voltage from 9-23VDC at 1 amp rating using the 2.1mm Barrel Jack or screw terminal block. You have three jumper positions on either rail for selecting the voltage you want. We offer voltages ranging from 9v, 5v or 3.3v. Since this board has dual rail output option, you can place the jumper on the left side to 9v for 9vdc and 3.3v on the right side for 3.3v on the right side. You will not need to worry about ground as the ground pins are connected together.
This board will not generate too much heat and has a reverse polarity connection protection for currents up to 1 amp.
Note: Requires soldering.
WARNING
