12VDC Battery Charging Controller Board XH-M601
This module allows you to set two threshold points to charge your battery packs. One being the charging threshold and the second being the disconnection threshold. By setting these values you will control the minimum and maximum charge your batteries will remain at a certain point.
Specifications
- Power Supply: 13.8V-14.8V
- Relay closing voltage: 12.4V
- Relay off voltage: 14.8V
- Voltage error:±0.1V
- Voltage detection: DC voltmeter
- Charging type: 12V battery
- Potentiometer adjustment: RP1 RP2 (carefully adjusted)
- PCB Board Size: 65mm x 52mm x 30mm / 2.56" x 2.05" x 1.18" (L x W x H)
Potentiometer Adjustment:
1.RP1:adjust storage battery start charging voltage (low voltage setting:clockwise becomes higher,counter-clockwise becomes lower)2.RP2:adjust storage battery disconnect charging voltage (low voltage setting:clockwise becomes higher,counter-clockwise becomes lower)
WARNING
