Chimera – Throat for 1.75mm Filament without PTFE Tube
This odd looking throat is designed and is to be used with chimera compatible devices only! This throat DOES NOT come with a 1.75mm PTFE inside, (see 3D-T-007 for model with Teflon Tube). This throat is designed to align and feed 1.75mm filament before entering the heating block. The smooth part of the throat is designed to enter a chimera compatible heat sink and is tighten with a hex nut to keep in place.
We recommend using some Teflon tape on the thread of the throat when attaching to the heating block.
Specifications:
- Length: 20 mm
- Diameter: 1.75mm filament only
- Gap from heating block and heatsink: 2mm
WARNING
