NTC 3950 100K Thermistor with Cable for 3D Printer (Aircraft JST)

NTC 3950 100K Thermistor with Cable for 3D Printer (Aircraft JST)

• A thermistor is a resistor whose value varies with temperature. This type of device is rated at 100K ohm.
• This particular product is used as replacement 3D printers extruder and heat bed to serve as temperature sensors.
• This unit is compatible with most 3D printer makes and comes with the cable pre-attached.
• A malfunctioning thermistor can have serious influences on the quality of a 3D print.
• The unit is quite easy to replace, simply pull it out and re-tape in the new with some Kapton thermal tape.
• In dire cases, some printer firmware allows you to calibrate the temperature PID control system values.
• It comes with a New type of JST pin.
• Easy to detach from thermistor whenever required.
• It is NTC Thermistor