PC6-01 Brass Blue Pneumatic Fittings for 3D Printers with Bowden setup Extruder
Feature- The Push-to-connect end can be rotated 360 degrees even after installation, which is convenient to use and has good sealing performance.
- Made of plastic and brass, with high strength, good sealing performance and long service life.
- Mainly used for air compression systems, vacuum systems, pneumatic systems.
1.Make sure that the cutting surface of the pipe is vertical. Please insert the tube into the bottom before use.
2.When inserting the pipe into the joint, it must be inserted into the end, otherwise there may be a leak.
3.After plugging in, try to pull the tube, if you can't pull it out, it means it has been connected.
4.When loosening the tube, first confirm that there is no pressure in the tube, and then evenly press the end cap to the bottom.
WARNING
