LCD12864 RAMPS 1.4 Arduino Mega Control Board A4988 Driver Kit For 3D Printer
The market is currently flooded with various 3D printers that can perform 3D printing with different materials. The cost for 3D printers are usually expensive since they are either pre-built or pre-design for a DIY kit. For users that have experience with 3D printers and want to use the RAMP 1.4 Based 3D printer Logic Controls, this kit will offer that for a reasonable price. This kit will not include the motors nor the frame and mechanical components to get it operational. This kit only focuses on the Control with the LCD Controller, RAMPS controller, 5 A4988 Drivers and an Arduino Mega.
Specifications:
RAMPS Controller –
- Power Via Power Supply AC to DC adapter from 6V-12VDC
- Recommend power Supply 9V
LCD12864 (LCD Controller) –
- LCD12864
- Standard SD Slot
- Plug and Play -> Requires Firmware Update for support
A4988 Driver –
- Low RDS (ON) Outputs
- Automatic Current damping Detection Mode
- Synchronous rectification for low power dissipation
- Internal UVLO
- Crossover Current Protection
- 3.3 and 5V compatible Logic
- Thermal Shutdown Protection
- Ground short Protection
- Load Short Protection
- Five selectable stepper motor modes: 1, ½, ¼, 1/8 and 1/16 speeds
Kit Includes:
- 12864 LCD Controller Board
- RAMPS 1.4 Controller Board
- Mega 2560 Compatible R3 Board
- A4988 Stepper Motor Drivers x 5
- USB A to USB B Cable
- Flat Cable Connector x 2
WARNING
