110VAC 600W 300x300mm Silicone Heating Pad for 3D Printers with a 100K Thermistor and a Double Sided 3M Tape
This silicone heating pad is highly recommended for your 3D printer as an upgrade option. With the right setup, it is capable of reaching up to 160 degrees Celsius within less than a few minutes! It also includes a 100K ohm thermistor built in the pad for easy wiring. This allows for printing harder materials such as ABS, Nylon, Polycarbonate, HIPS, etc..
The heatpad runs on 110VDC with less current draw which is a lot safer than running at 12VDC with double the amount of current draw. Temperature spread is uniform compared to the regular PCB heatbed.
It is recommended to do a PID tune after installing this heatpad for best 3D printing experience.
WARNING
