This is a DC plug Arduino compatible kit with an ATmega328 chip. This clone acts just like an Arduino, and works with the latest Arduino software. For many projects it can even be preferable! The kit includes all parts necessary, the assembly is straightforward and well documented.
Adding quality audio to an electronic project is surprisingly difficult. Here is a shield for Arduinos that solves this problem. It can play up to 22KHz, 12bit uncompressed audio files of any length. It's low cost, available as an easy-to-make kit.
Wow that's a tiny GPS antenna! This passive antenna is only 9mm x 9mm x 6.5mm in size, with a 50mm long uFL cable. Great for when you want to keep things small. Comes with a standard uFL connector on the end.
That new Raspberry Pi® Model B+ computer you just got has a row of 2x20 pin headers soldered on - those are the GPIO (general purpose input/output) pins and for those of us who like to hack electronics they are where the real fun is. By programming the Pi, you can twiddle those pins high or low, send and receive I2C and SPI data, and access the 3V and 5V power rails. This cable is not compatible with the Raspberry Pi Model B or Model A! If you want to bridge those contacts out onto another PCB, you'll want this cable! It's 6" long and has 40 socket & wire sets. Pin #1 is marked with a white wire.
Includes encapsulated laser diodes that are Class IIIa 5mW, with a 650nm red wavelength. They can be driven from 2.8V to 5.2V so they're great for your embedded electronics project.
This is specifically designed for people who want to program Atmega328P's to turn them into Arduino bootloader chips using an AVR-ISP sketch, but it can also be used to make a 'standalone' AVR ISP programmer - so that you can program blank chips without a computer!
The product kit comes with: A fully tested and assembled LED backpack. Ultra-bright 4-digit 0.56" tall red seven-segment display. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes.
The product kit comes with: A fully tested and assembled LED backpack. Ultra-bright 4-digit 0.56" tall green seven-segment display. 4-pin header. A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes.
Compatible with both male and female wires, these fully customizable wire housings bring DIY to a new level, giving you near limitless options when using jumper wires in your project. This is a pack of small, single row housings. This pack includes: 10 x 1x1 housing, 10 x 1x2 housing, 10 x 1x3 housing, 10 x 1x4 housing, 10 x 1x5 housing.
