Ginsberg Scientific Inc.

1 - 8
2 3 4 5 6 7 8 9
US$49.28
The 1/2" thick vacuum plate was designed to fit any jar 8-1/2" O.D. or smaller. A rubber gasket is also included. 9" outside diameter.
In stock
+
Add to wish list

US$53.90
These Laboratory Scissor Jacks are great for supporting glassware and other lab items at a stable and precise height. The jack will extend to a maximum height of 10 inches. These Scissor Jacks come in Black enamel finish or Stainless Steel.
In stock
+
Add to wish list

US$56.21
These Barnes dropping bottles are square bottles made of heavy clear glass with a pipette and rubber bulb stopper.
In stock
+
Add to wish list

US$59.00
Unit has a high-power silicon cell which converts light directly into electricity to operate a motor. Exceptionally high output 1/2v with 300 milliamps of current output in bright sunlight. Solar cell approximately 2" x 3" with plastic diffusing lens and protective mounting. Motor with special anti-friction bearings revolves approximately 400 RPM in bright sunlight.
In stock
+
Add to wish list

US$107.80
This is a 4 piece high quality Precision Measurement Set in a high impact reusable plastic storage container. Includes: 1-Micrometer 0-25 x .01mm. 1-Vernier Caliper 150 x .05mm. Knife edge square 90 degrees. Ruler Steel 150mm.
In stock
+
Add to wish list

US$112.35
This kit can be used to demonstrate most of the principles of electricity. Supplied with an easily understood instruction manual. The kit contains the following: Voltmeter 0-1.5; 0-3v, Milliammeter 0-500 mA; 0-1000mA, Electroscope, Battery Kit, Mini Rheostat, Two Bar Magnets 2" in length, Compass Needle, Two Resistors, Mini Electromagnet, Horseshoe Magnet, Two Mini Contact Switches, Two Bulb Holders, Package of Iron Filings, Battery Holder D-Cell, Coil of Wire, Steel Rod Electromagnet, Acrylic Piece 19mm x 120mm, Two Plastic Rods 5mm x 120mm.
In stock
+
Add to wish list

US$392.00
This is perfect for classroom demonstrations of the effect a load has on a power source. The field of this magneto consists of a single Alnico magnet, which has a strong magnetic flux density. Capable of producing higher voltages then cobalt-steel magnets. The generator is mounted on 7 5/8" x 12" wood base with incandescent lamp and socket used as a load. Two binding posts are placed on the board for attaching other loads. Complete with instructions. (16" x 8" x 6"; 6Ibs).
In stock
+
Add to wish list
1 - 8
2 3 4 5 6 7 8 9