The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.
This is a pre-wired and waterproofed version of the DS18B20 sensor made with a PTFE wire cable.
The MAX31855K does everything for you, and can be easily interfaced with any microcontroller, even one without an analog input. This breakout board has the chip itself, a 3.3V regulator with 10uF bypass capacitors and level shifting circuitry, all assembled and tested.
The Adafruit panel current meter is handy device to have display when you want to monitor or view the current flow situation in a circuit application. This panel meter requires a DC voltage to run, and then has two thick gauge wires to measure current draw. A shunt is already on board so its very easy to hook up!
Build your own ambient-light addition for a monitor or media PC television with the Adalight project pack!. By running the Processing code on your computer, the halo of LEDs will follow the screen colors to provide an awesome ambient light display that adds pop to TV shows, movies or games! Works using open source Processing and Arduino - so it'll run on Mac, Windows or Linux computers!
This is an assortment of the most common sensors used in electronics. 9 sensors and 3 additional components to interface with the 'analog world'.
