AVR

US$24.99

This is an ATMEL KK2.X AVR programmer which allows you to communicate with your supported flight controller and flash a firmware to it.

 

In stock
+
Add to wish list

US$181.77
Atmel-ICE-C is the cost effective solution for the powerful Atmel-ICE, it adopts the original ATMEL-ICE-PCBA and comes with a durable aluminium alloy enclosure. Atmel-ICE-C delivers the same functionality and usability just as the ATMEL-ICE Full Kit, it is capable of debugging and programming Atmel ARM® Cortex®-M based Atmel SAM and AVR® microcontrollers with on-chip debug capability.
In stock
+
Add to wish list

US$22.50
This is a USB AVR programmer supported by offical Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to reburn the bootloader and save the dead Arduino. This programmer works really well for ATmega168 and ATmega328 and should work with all the AVR micros supported by AVRDUDE. Both 10-pin and 6-pin targets supported (cable included) which makes the progrmmer suitable for most AVR boards.
In stock
+
Add to wish list

US$13.99

Small generic AVR programmer encased in hard plastic, with a 10-pin cable included. Use USBasp in arduino to program your controller. Supports 3.3V and 5V (you have to open up the case to flip a switch). Support for AVRDude from version 5.2 onwards. Support for Linux, Mac OS X and Windows. Maximum write speed: 5KB/sec.

In stock
+
Add to wish list

US$28.75
XSP Programmer is designed for Arduino/AVR device. It is a driver free programmer, supporting Arduino/AVR ISP and FTDI programming. It could provide both 5V and 3.3V power output or self-adaption power output(OFF mode). Support Xbee socket and auto-match ISP clock frequency.
In stock
+
Add to wish list

US$17.97
This premade board acts like a AVR programmer and uses SPI Interface. Works with avrdude (cmd) or avrdudess (GUI) and AVRStudio-compatible. You can flash firmwares using this tiny programmer or bitbang commands to avr chipsets.
In stock
+
Add to wish list

US$10.32
This programmer is based on Thomas Fischl’s USBasp design and connects your computer’s USB port to your microprocessor using SPI. This device is supported in AVRDude version 5.2 and onwards, Allows you to read/write to any atmel based microprocessors. Works in windows 7/8/10, Mac and Linux.
In stock
+
Add to wish list

US$28.06
This plugs directly into your USB port and provides a programming socket for the ATTiny45 and 85. Just slot an ATtiny into the socket, plug the programmer into your USB port and start up the Arduino IDE.
Delivery within 2-3 weeks
+
Add to wish list

US$38.50
USBtinyISP is a simple open-source USB AVR programmer and SPI interface. It is low cost, easy to make, works great with avrdude, has both 6 and 10 pin standard ISP cables, is AVRStudio-compatible and tested under Windows XP and MacOS X, it may or may not work with your specific Vista/Windows 7 system.
In stock
+
Add to wish list

US$27.93
This device is a programmer for AVR-based controllers, such as the Pololu Orangutan robot controllers and the 3pi robot. The programmer emulates an STK500 on a virtual serial port, making it compatible with standard AVR programming software.
In stock
+
Add to wish list

US$21.00

This breakout AVR board is a prototype design with minimum components. We took the business-card-sized AVR target board from Evil Mad Scientist Laboratories and added a few components to make an AVR dev board that has only the bare minimums!

In stock
+
Add to wish list