ITEAD PN532 13.56MHz NFC/RFID Card Reader Arduino and Raspberry Pi module
This an ITEAD NFC and RFID card reader module built around the PN532 chip. This module reads 13.56MHz cards/tags within 3cm and uses near field communication technology to do so. With only 5V needed to supply the board, NFC library support provided by ITEAD and a 20 pin STD interface, you can easily hook it up to your ARDUINO or RASPBERRY PI platforms. Not only that, but this module is also compatible with three of the most popular communication protocols SPI, UART and I2C allowing you to seamlessly configure it to whichever one of those three with the help of two slide switches. No need to tinker with the software. If you’re looking for a low-cost and easily configurable alternative for NFC/RFID card reading, this module is a great pick.
Specifications:
- IC: NXP PN532
- Power Supply Voltage: 3.3-5.5V
- Max Supply Current:150mA
- Working Current (Standby Mode):100mA
- Working Current (Write Mode):120mA
- Working Current (Read Mode):120mA
- Max distance: 3cm
- Compatibility: ISO14443 Type A and Type B
- Dimensions: 79mm x 49mm / 3.11 in x 1.93 in
- Raspberry PI Board is not included.
- Writable Tags and Cards included.
WARNING
