FT245

The FT245 EVAL BOARD provides a high-performance cost-effective solution for USB TO 8-BIT FIFO. It is based on the FT245RL chip and will hopefully allow to try out the full potential of the FT245 device before using it in your prototype. The FT245RL is a USB to parallel FIFO interface device which simplifies USB to FIFO designs and reduces external component count by fully integrating an external EEPROM, USB termination resistors and an integrated clock circuit which requires no external crystal, into the device. It has been designed to operate efficiently with a USB host controller by using as little as possible of the total USB bandwidth available.

The FT245 USB FIFO Board (type A) is an accessory board that provides a USB to parallel FIFO interface, with FT245 chip onboard, also features USB Type A connector, and control interface (8 data pins & 6 control pins). The FT245 USB FIFO Board (type A) is ideal for establishing communication between MCU and PC. There is also a jumper used for selecting VCC output level provided on the board.

The FT245 USB FIFO Board (mini) is an accessory board that provides a USB to parallel FIFO interface, with FT245 chip onboard, also features USB mini-AB connector, and control interface (8 data pins & 6 control pins). The FT245 USB FIFO Board (mini) is ideal for establishing communication between MCU and PC. There is also a jumper used for selecting VCC output level provided on the board.