EMX-FC-0109 OpenPilot CC3D EVO 32-Bit Flight Controller with Straight Pins
The CC3D boards are an all-in-one stabilization hardware which runs the OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the OpenPilot Ground Control Station (GCS) software. The retail CC3D board comes with the CC3D REV C+ board, an assortment of wires to connect to the Flexi port, main port and Flexi I/O port. It also has complementary nylon nuts, standoffs and bolts with Philips head for mounting the board. This system has an integrated IMU onboard.
The CC3D hardware has the following features:
Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.
Tiny 36x36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
Software support for Windows, Mac and Linux.
Direct high speed USB support with no drivers required, a truly plug and play device.
Spektrum satellite receiver support.
Futaba S-BUS hardware support.
Innovative Flexi-port technology for superior port flexibility.
4Mbits on-board EEPROM for configuration storage.
CC3D also offers the innovative Flexi-port which provides either I2C connectivity or a second serial port. Flexi-port gives CC3D the flexibility to use either I2C and a single serial port or dual serial ports, according to your connectivity needs.
Superior user experience
OpenPilot is easy and trouble-free to use with the hardware completed; there is nothing to solder. The included RC harness allows you to connect any standard PWM receiver. Standard mini-USB cable is used to load the latest firmware and configure everything for your unique airframe. OpenPilot software is designed to be used by everybody! All major operating systems are supported and install packages are provided. The software is all Free software under the GPLv3 license.
Dimensions: 3.6 x 3.6 x 0.5 cm (L x W x H)
1x CC3D flight controller
4x Plastic Nylon Screw+Standoff+Nut
2x 4 pin expansion path
1x 1 pin expansion path