ITEAD Studio

US$4.19
By tilting to different end, it acts On/Off like a switch.
In stock
+
Add to wish list

US$19.53

This shield is with 2 channels mechanical relays and 2 channels MOS switch, providing an easy way for applications of voltage controlling from low to high.

In stock
+
Add to wish list

US$41.93

It's based on RoyalTek REB-4216 GPS module, and the footprints is compatible with Arduino/MEGA boards. The regular GPS pins (RX, TX) can be connected to D0-D7 of Arduino. Adding GPS to your Arduino has never been easier. Multiple GPS receivers attach easily to the shield, and with the example sketch (check below), you will be able to locate your exact position within a few meters. Here's where we are. GPS also gives you amazingly accurate time!  It’s suitable for the following applications with Arduino or Arduino compatible boards : Automotive navigation, Personal positioning, Fleet management, Marine navigation.

In stock
+
Add to wish list

US$12.59
This is a 3X3 key-pad shield with a 5110 Graphic LCD interface.
In stock
+
Add to wish list

US$27.93

Screen is a common display device, we provide 16×2, 8×2, 20×4 with Yellow / Blue black light LCD. But these LCD need more than 6 pins for controlling and you need to know the control register and time series.

In stock
+
Add to wish list

US$2.09
This is a 3 Pin Dual-female to Grove 4 pin Converter Cable.
In stock
+
Add to wish list

US$9.79
Electronic brick of electricity sensor is based on TA12-100 current transformer, which can transform AC signals of large current into small amplitude signals. The maximum current that can be detected can reach 5A, and the present current signal can be read via analog I / O port.
In stock
+
Add to wish list

US$4.19
Brick Power Supply: 5V. Brick Interface: 3PIN. Uses the photoresistor to detect the light intensity of the environment. Each terminal module has buckled port with VCC, GND and Output.
In stock
+
Add to wish list

US$4.55
This is an electronic module which can be assembled like Lego bricks simply by plugging in and pulling out.
In stock
+
Add to wish list

US$3.15
This is an electronic module which can be assembled like Lego bricks simply by plugging in and pulling out.
In stock
+
Add to wish list

US$4.13
An electronic brick is an electronic module which can be assembled like Lego bricks simply by plugging in and pulling out. Compared to traditional universal boards and circuit modules assembled with various electronic components, electronic brick has standardized interfaces, plug and play, simplifying construction of prototype circuit on one’s own.
In stock
+
Add to wish list

US$4.13
This display has 64 Red LEDs packed into a 20mm x 20mm dot matrix display. Great for displaying text or creating bizarre lighting patterns.
In stock
+
Add to wish list